How to Fix a Hole in Drywall Without a Patch – Drywall, also known as wallboard, is a type of board made of plaster, wood pulp, or another material that is used to construct the interior walls of homes. However, just because it isn’t made of stone or other solid materials doesn’t mean it can’t crack or have a hole in the surface.
But don’t worry, the hole or crack, like any other type of wall, can be repaired. There are numerous methods for repairing drywall. The methods used are determined by the size and location of the drywall hole or crack.
If you have a small hole in your drywall, you will need a different approach than if you have a large hole. A crack in the seam will necessitate a different repair than a crack in the corner of the wall.
In general, drywall repair is easy and affordable. However, the repair may take some time to complete. After you’ve finished the repair, you’ll need more time for the mud/spackling to dry before sanding and painting the drywall.
In this article, we will tell you how to fix a hole in drywall without a patch, you may need some tools to help you repair the wall. Make sure you are prepared to fix the wall. Here are the steps to fix drywall without a patch:
How to Fix a Hole in Drywall Without a Patch
There are times when you can take shortcuts to repair a hole in your wall. The fundamental idea is as follows: To spackle or mud over a hole, the compound must have something to bind itself to inside the gap.
therefore, if you have something to “plug” the hole. that joint compound will hold securely in-place, you can make the repair, and no one will recognize the change.
Read More: How To Repair Large Cracks In Concrete Driveway
Another alternative is using a California Patch – or butterfly patch – which is simply a small, square piece of drywall that has been modified so that the paper itself holds the drywall plug in place.
This method is simple, especially if you are handy or familiar with utility knife, however it only works for holes less than 8″ in diameter. Here are the steps:
- Shape the existing hole with a jab saw or utility knife into a square or rectangle shape.
- Cut the drywall scrap into a similar shape that is 3″ larger on all sides than the hole.
- Flip the scrap over and measure the diameter of the hole that needs to be patched.
- In the center of the scrap, trace a hole lesser than the one to be plugged in the wall.
- Cut around the tracing on the scrap and peel the gypsum away from the paper, you should leave a small patch of drywall in the center and 2″ of paper around the wall.
- Apply joint compound to the hole and the surrounding area to make room for the patch/paper.
- Apply the California patch, blending the plug and sanding down the mud with the utility knife.
- And then Apply another layer of mud over the patch, smoothing it out beyond the patch’s edges to blend in with the surrounding wall.
- Let the mud dry for 24 hours before proceed to sanding the wall.
- Apply a second layer of mud and let it dry overnight.
- Sand again, then put paint on the wall
After you did all the steps above, Voila! You can finally fix your drywall without a patch.